H3C Technologies H3C S5830V2 Series Switches - Manual (Page 106)

95
You can specify N_Ports as members of a zone by using their FC addresses, pWWNs, or zone aliases.
These N_Ports can be indirectly connected to the switch. An N_Port can belong to more than one zone.
To configure a zone:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Create a zone and enter
its view.
zone name zone-name
If the zone has been created, enter
its view directly.
4. Add a member to the
zone. member { fcid fcid | pwwn pwwn |
zone-alias zone-alias-name } By default, no member exists in a
zone.
Configuring zone sets
You can configure a maximum of 128 zone sets for all VSANs on a switch.
To configure a zone set:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Create a zone set (if the
zone set does not exist)
and enter its view. zoneset name zoneset-name N/A
4. Add a zone to the zone
set.
member zone-name
By default, no zone exists in a zone
set.
Configuring the default zone policy
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Permit members in the
default zone to access
each other. zone default-zone permit Use one of the commands.
By default, default zone members
are not permitted to access each
other. 4. Deny members in the
default zone from
accessing each other.
undo zone default-zone permit