H3C Technologies H3C S5830V2 Series Switches - Manual (Page 54)

43
Tasks at a glance Remarks
(Required.) Setting a fabric name
When statically building a fabric, you must
manually configure the fabric name, and
make sure all switches in the fabric are
configured with the same fabric name.
(Optional.) Configuring the allowed domain ID list N/A
(Required.) Configuring a domain ID for a switch
When statically building a fabric, you must
manually configure a domain ID for each
switch.
(Optional.) Binding the WWN of an N_Port to an FC address N/A
(Optional.) Configuring the fabric timers N/A
(Optional.) Configuring RSCN aggregation N/A
(Optional.) Configuring and obtaining FC4 information of nodes N/A
Building a fabric dynamically
Tasks at a glance Remarks
(Required.) Enabling or disabling the fabric configuration
function
To dynamically build a fabric, you must
enable the fabric configuration function.
(Optional.) Setting the switch priority
Principal switch selection relies on the
switch priority.
(Optional.) Configuring the allowed domain ID list N/A
(Optional.) Configuring a domain ID for a switch
When dynamically building a fabric, you
can configure domain IDs for switches.
(Optional.) Binding the WWN of an N_Port to an FC address N/A
(Optional.) Configuring the fabric timers N/A
(Optional.) Configuring the fabric reconfiguration N/A
(Optional.) Configuring an FC interface to reject incoming RCF
requests
N/A
(Optional.) Enabling SNMP notifications for the fabric or name
service module
N/A
(Optional.) Configuring RSCN aggregation N/A
(Optional.) Configuring and obtaining FC4 information of nodes N/A
Enabling or disabling the fabric configuration
function
After you enable the fabric configuration function on FC switches, the switches exchange messages to
select the principal switch. Then the principal switch dynamically assigns domain IDs to all switches in the
fabric. After you disable the fabric configuration function on FC switches, the switches will not select a