H3C Technologies H3C S5830V2 Series Switches User Manual
Page 68
57
Saved the current configuration to mainboard device successfully.
[SwitchB] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
[SwitchB] fcoe-mode fcf
# Enable the fabric configuration function for VSAN 1. This step is optional because the fabric
configuration function is enabled by default.
[SwitchB] vsan 1
[SwitchB-vsan1] domain configure enable
# Set the priority value to 1, so that Switch B can be selected as the principal switch.
[SwitchB-vsan1] priority 1
3.
Configure Switch C:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchC] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchC] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
[SwitchC] fcoe-mode fcf
# Enable the fabric configuration function for VSAN 1. This step is optional because the fabric
configuration function is enabled by default.
[SwitchC] vsan 1
[SwitchC-vsan1] domain configure enable