H3C Technologies H3C S5830V2 Series Switches - Manual (Page 27)

16
Step Command Remarks
4. (Optional.) Configure the
interface rate.
speed { 1000 | 2000 |
4000 | 8000 | 16000 |
auto }
By default, the speed of an FC interface is
autonegotiated.
5. (Optional.) Configure a
description for the FC
interface.
description text
By default, the description of an FC interface is
in the format FC interface name Interface, for
example, Fc1/0/1 Interface.
6. (Optional.) Configure the
BB_Credit value for the
FC interface.
fcb2bcredit credit-value The default setting is 15.
7. (Optional.) Configure the
fill word mode for the FC
interface.
fill-word { idle-arbff |
idle-idle }
By default, the fill word mode is idle-arbff for
an FC interface operating at 8 Gbps.
This command is available on only FC
interfaces operating at 8 Gbps. This command
does not take effect on FC interface operating
at 2 Gbps or 4 Gbps, and these FC interfaces
supports only the fill word mode idle-idle.
To make the fill word mode configuration take
effect, you must re-enable the FC interface by
using the shutdown command and then the
undo shutdown command.
8. (Optional.) Configure the
expected bandwidth of
the interface.
bandwidth
bandwidth-value By default, the expected bandwidth (in kbps) is
the interface baud rate divided by 1000.
9. (Optional.) Restore the
default settings for the FC
interface.
default N/A
10. Bring up the FC
interface.
undo shutdown By default, an FC interface is up.
Displaying and maintaining FC interfaces
Execute display commands in any view and reset commands in user view.
Task Command
Display FC interface information.
display interface [ fc ] [ brief [ down ] ]
display interface [ fc [ interface-number ] ] [ brief
[ description ] ]
Clear the statistics for FC interfaces. reset counters interface [ fc [ interface-number ] ]