Network requirements, Configuration procedure – H3C Technologies H3C S5830V2 Series Switches User Manual
Page 156
145
The output shows that Switch A can reach Switch B, but Switch B cannot reach Switch C. Therefore,
you can use the display fc routing-table command on Switch B to see whether there is a route to
Switch C.
FC tracert configuration example by using VFC interfaces
Network requirements
As shown in
, detect bidirectional routing information between Switch A and Switch C, and
identify the faulty node (if any).
Figure 43 Network diagram
Configuration procedure
1.
Configure Switch A:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
[SwitchA] fcoe-mode fcf
# Enable the fabric configuration function for VSAN 1.
[SwitchA] vsan 1
[SwitchA-vsan1] domain configure enable
# Configure the domain ID as 1 for the switch.