H3C Technologies H3C S5830V2 Series Switches User Manual

Page 155

144

# Enable the fabric configuration function for VSAN 1.

[SwitchC] vsan 1

[SwitchC-vsan1] domain configure enable

# Configure the domain ID as 3 for the switch.

[SwitchC-vsan1] domain-id 3 static

[SwitchC-vsan1] quit

# Change Ethernet interface Ten-GigabitEthernet 1/0/2 into FC interface FC 1/0/2.

[SwitchC] interface ten-gigabitethernet 1/0/2

[SwitchC-Ten-GigabitEthernet1/0/2] port-type fc

# Configure the mode of interface FC 1/0/2 as E.

[SwitchC-Fc1/0/2] fc mode e

# Configure interface FC 1/0/2 to autonegotiate the speed.

[SwitchC-Fc1/0/2] speed auto

# Configure the trunk mode of interface FC 1/0/2 as On, and assign interface FC 1/0/2 to
VSAN 1 as a trunk port.

[SwitchC-Fc1/0/2] port trunk mode on

[SwitchC-Fc1/0/2] port trunk vsan 1

[SwitchC-Fc1/0/2] quit

# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.

[SwitchC] vlan 10

[SwitchC-vlan10] fcoe enable vsan 1

[SwitchC-vlan10] quit

# Disable FSPF for VSAN 1.

[SwitchC] vsan 1

[SwitchC-vsan1] undo fspf enable

On Switch A, use the fcping command to ping Switch C and identify whether Switch C is

reachable.

[SwitchA-vsan1] fcping fcid fffc03 vsan 1

FCPING fcid 0xfffc03: 128 data bytes, press CTRL_C to break.

Request time out

--- 0xfffc03 fcping statistics ---

5 packet(s) transmitted

0 packet(s) received

100.00% packet loss

The output shows that Switch A cannot reach Switch C.

Use the fctracert command to identify the faulty node.

[SwitchA-vsan1] fctracert fcid fffc03 vsan 1

Route present for: 0xfffc03, press CTRL_C to break

20:00:00:0b:46:00:02:82(0xfffc01)

20:00:00:05:30:00:18:db(0xfffc02)

Fctracert uncompleted: no route to destination port.