H3C Technologies H3C S5830V2 Series Switches User Manual

Page 82

Start to check configuration with next startup configuration file, please

wait.........DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

# Configure the switch to operate in FCF mode.

system-view

[SwitchB] fcoe-mode fcf

# Enable the fabric configuration function for VSAN 1.

[SwitchB] vsan 1

[SwitchB-vsan1] domain configure enable

# Configure the domain ID as 2.

[SwitchB-vsan1] domain-id 2 static

[SwitchB-vsan1] quit

# Change Ethernet interface Ten-GigabitEthernet 1/0/1 into FC interface FC 1/0/1.

[SwitchB] interface ten-gigabitethernet 1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port-type fc

# Configure the mode of interface FC 1/0/1 as E.

[SwitchB-Fc1/0/1] fc mode e

# Configure interface FC 1/0/1 to autonegotiate the speed.

[SwitchB-Fc1/0/1] speed auto

# Configure the trunk mode of interface FC 1/0/1 as On, and assign interface FC 1/0/1 to
VSAN 1 as a trunk port.

[SwitchB-Fc1/0/1] port trunk mode on

[SwitchB-Fc1/0/1] port trunk vsan 1

[SwitchB-Fc1/0/1] quit

# Change Ethernet interface Ten-GigabitEthernet 1/0/2 into FC interface FC 1/0/2.

[SwitchB] interface ten-gigabitethernet 1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port-type fc

# Configure the mode of interface FC 1/0/2 as E.

[SwitchB-Fc1/0/2] fc mode e

# Configure interface FC 1/0/2 to autonegotiate the speed.

[SwitchB-Fc1/0/2] speed auto

# Configure the trunk mode of interface FC 1/0/2 as On, and assign interface FC 1/0/2 to
VSAN 1 as a trunk port.

[SwitchB-Fc1/0/2] port trunk mode on

[SwitchB-Fc1/0/2] port trunk vsan 1

[SwitchB-Fc1/0/2] quit

# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 1

[SwitchB-vlan10] quit

# Configure two static routes.

[SwitchB] vsan 1

[SwitchB-vsan1] fc route-static 010000 8 fc 1/0/1

[SwitchB-vsan1] fc route-static 030000 8 fc 1/0/2

Configure Switch C: