H3C Technologies H3C S5830V2 Series Switches - Manual (Page 163)

152
To transmit the storage traffic of VSAN 100 within VLAN 4001, map VLAN 4001 to VSAN 100.
To avoid physical loops in the LAN, enable STP on the Ethernet interfaces connecting Switch A and
Switch B to the LAN and the server. To prevent STP from blocking the interfaces used for forwarding
storage traffic on Switch A and Switch B, disable STP on the interfaces connecting the four FCF switches.
For the server to access the resources in the disk device, configure the members in the default zone to
access each other.
To increase the bandwidth for the link between Switch A and Switch C and the link between Switch B and
Switch D and implement link backup and load sharing, configure Ethernet link aggregation groups 1
and 2, respectively.
Configuration restrictions and guidelines
When the SANs are complex, H3C recommends that you build the fabric dynamically and use FSPF for
FC routing.
Configuration procedures
Configuring Switch A
1. Enable the advanced mode:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the system
to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
2. Configure VLANs and interfaces:
# Create VLAN 1001 and 4001, which are intended to transmit Ethernet traffic and storage traffic,
respectively.
system-view
[SwitchA] vlan 1001
[SwitchA-vlan1001] description ToLAN