beautypg.com

Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual

Page 46

background image

33

IPv6 NTP symmetric active/passive mode

configuration example

Network requirements

As shown in

Figure 11

, Device C has a clock more accurate than Device A.

Set the local clock of Device A as a reference source, with the stratum level 3.

Set the local clock Device C as a reference source, with the stratum level 2.

Configure Device B to operate in client mode and specify Device A as the IPv6 NTP server of Device
B.

Configure Device C to operate in symmetric-active mode and specify Device B as the IPv6 passive
peer of Device C.

Figure 11 Network diagram

Configuration procedure

1.

Set the IP address for each interface as shown in

Figure 11

. (Details not shown.)

2.

Configure Device A:
# Enable the NTP service.

system-view

[DeviceA] ntp-service enable

# Specify the local clock as the reference source, with the stratum level 3.

[DeviceA] ntp-service refclock-master 3

3.

Configure Device B:
# Enable the NTP service.

system-view

[DeviceB] ntp-service enable

# Specify Device A as the IPv6 NTP server of Device B.

[DeviceB] ntp-service ipv6 unicast-server 3000::34

4.

Configure Device C:
# Enable the NTP service.