H3C Technologies H3C S6300 Series Switches User Manual
Page 186
173
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure source ports for the
specified remote source
group.
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
By default, no source port is
configured for a remote source
group.
Configuring a source port for a remote source group in interface view
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure the port as a source
port for the specified remote
source group.
mirroring-group group-id
mirroring-port { both | inbound |
outbound }
By default, a port does not act as a
source port for any remote source
group.
Configuring the egress port for a remote source group
To configure the egress port for a remote source group, use one of the following methods:
•
Configure the egress port for the remote source group in system view.
•
Assign a port to the remote source group as the egress port in interface view.
When you configure the egress port for a remote source group, follow these restrictions and guidelines:
•
Disable the following features on the egress port:
{
Spanning tree.
{
802.1X.
{
IGMP snooping.
{
Static ARP.
{
MAC address learning.
•
A mirroring group contains only one egress port.
•
A port of an existing mirroring group cannot be configured as an egress port.
Configuring the egress port for a remote source group in system view
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the egress port for
the specified remote source
group.
mirroring-group group-id
monitor-egress interface-type
interface-number
By default, no egress port is
configured for a remote source
group.
Configuring the egress port for a remote source group in interface view