H3C Technologies H3C S6300 Series Switches User Manual
Page 184
171
•
Configure the monitor port for the mirroring group in system view.
•
Assign a port to the mirroring group as the monitor port in interface view.
When you configure the monitor port for a remote destination group, follow these restrictions and
guidelines:
•
Do not enable the spanning tree feature on the monitor port.
•
Use a monitor port only for port mirroring, so the data monitoring device receives and analyzes
only the mirrored traffic.
•
A mirroring group must contain only one monitor port, and a monitor port can belong to only one
mirroring group.
Configuring the monitor port for a remote destination group in system view
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the monitor port for
the specified remote
destination group.
mirroring-group group-id
monitor-port interface-type
interface-number
By default, no monitor port is
configured for a remote
destination group.
Configuring the monitor port for a remote destination group in interface view
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure the port as the
monitor port for the specified
remote destination group.
mirroring-group group-id
monitor-port
By default, a port does not act as
the monitor port for any remote
destination group.
Configuring the remote probe VLAN for a remote destination group
When you configure the remote probe VLAN for a remote destination group, follow these restrictions and
guidelines:
•
Only an existing static VLAN can be configured as a remote probe VLAN.
•
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively.
•
Configure the same remote probe VLAN for the remote destination groups on the source and
destination devices.
To configure the remote probe VLAN for a remote destination group:
Step Command
Remarks
1.
Enter system view.
system-view
N/A