beautypg.com

Udp jitter operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual

Page 159

background image

146

# Enable the saving of history records.

[DeviceA-nqa-admin-test1-http] history-record enable

[DeviceA-nqa-admin-test1-http] quit

# Start the HTTP operation.

[DeviceA] nqa schedule admin test1 start-time now lifetime forever

# After the HTTP operation runs for a period of time, stop the operation.

[DeviceA] undo nqa schedule admin test1

# Display the most recent results of the HTTP operation.

[DeviceA] display nqa result admin test1

NQA entry (admin admin, tag test1) test results:

Send operation times: 1 Receive response times: 1

Min/Max/Average round trip time: 64/64/64

Square-Sum of round trip time: 4096

Last succeeded probe time: 2011-11-22 10:12:47.9

Extended results:

Packet loss ratio: 0%

Failures due to timeout: 0

Failures due to disconnect: 0

Failures due to no connection: 0

Failures due to internal error: 0

Failures due to other errors: 0

# Display the history records of the HTTP operation.

[DeviceA] display nqa history admin test1

NQA entry (admin admin, tag test1) history records:

Index Response Status Time

1 64 Succeeded 2011-11-22 10:12:47.9

The output shows that Device A uses 64 milliseconds to obtain data from the HTTP server.

UDP jitter operation configuration example

Network requirements

As shown in

Figure 43

, configure a UDP jitter operation to test the jitter, delay, and round-trip time

between Device A and Device B.

Figure 43 Network diagram

Configuration procedure

1.

Assign each interface an IP address. (Details not shown.)

2.

Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)

3.

Configure Device B: