Http template configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual
Page 176: Ftp template configuration example
163
HTTP template configuration example
Network requirements
As shown in
, configure an HTTP template for a feature to perform the HTTP operation to test
whether the NQA client can establish a connection to and get data from the HTTP server.
Figure 54 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Create HTTP template http.
[DeviceA] nqa template http http
# Specify the URL of the server.
[DeviceA-nqatplt-http-http] url
# Configure the HTTP operation to get data from the HTTP server. (The default HTTP operation type is get,
and this step can be omitted.)
[DeviceA-nqatplt-http-http] operation get
# If the number of consecutive successful probes reaches 2, the operation succeeds. The NQA client
notifies the feature of the successful operation event.
[DeviceA-nqatplt-http-http] reaction trigger probe-pass 2
# If the number of consecutive probe failures reaches 2, the operation fails. The NQA client notifies the
feature of the operation failure.
[DeviceA-nqatplt-http-http] reaction trigger probe-fail 2
FTP template configuration example
Network requirements
As shown in
, configure an FTP template for a feature to perform the FTP operation to test
whether Device A can establish a connection to Device B and upload a file to the FTP server. The login
username is admin, the login password is systemtest, and the file to be transferred to the FTP server is
config.txt.
Figure 55 Network diagram