Protocols and standards, Fips compliance, Netconf configuration task list – H3C Technologies H3C S6300 Series Switches User Manual
Page 240: Enabling netconf over soap
227
Protocols and standards
•
RFC 3339, Date and Time on the Internet: Timestamps
•
RFC 4741, NETCONF Configuration Protocol
•
RFC 4742, Using the NETCONF Configuration Protocol over Secure SHell (SSH)
•
RFC 5277, NETCONF Event Notifications
•
RFC 5539, NETCONF over Transport Layer Security (TLS)
•
RFC 6241, Network Configuration Protocol
FIPS compliance
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode (see Security Configuration Guide) and non-FIPS
mode.
NETCONF configuration task list
Task at a glance
(Optional.) Enabling NETCONF over SOAP
(Optional.) Enabling NETCONF over SSH
(Required.) Establishing a NETCONF session
(Optional.)
Subscribing to event notifications
(Optional.)
Locking/unlocking the configuration
(Optional.)
Performing the get/get-bulk operation
(Optional.)
Performing the get-config/get-bulk-config operation
(Optional.)
Performing the edit-config operation
(Optional.)
Saving, rolling back, and loading the configuration
(Optional.)
(Optional.)
Performing CLI operations through NETCONF
(Optional.)
Retrieving NETCONF session information
(Optional.)
Terminating another NETCONF session
(Optional.)
Enabling NETCONF over SOAP
NETCONF messages can be encapsulated into SOAP messages and transmitted over HTTP and HTTPS.
After enabling NETCONF over SOAP, you can develop Web configuration interface to perform
NETCONF operations.
To enable NETCONF over SOAP: