beautypg.com

Dlsw operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual

Page 168

background image

155

Min SD delay: 0 Min DS delay: 0

Number of SD delay: 4 Number of DS delay: 4

Sum of SD delay: 1390 Sum of DS delay: 1079

Square-Sum of SD delay: 483202 Square-Sum of DS delay: 973651

SD lost packets: 0 DS lost packets: 0

Lost packets for unknown reason: 0

Voice scores:

Max MOS value: 4.38 Min MOS value: 4.38

Max ICPIF value: 0 Min ICPIF value: 0

DLSw operation configuration example

Network requirements

As shown in

Figure 48

, configure a DLSw operation to test the response time of the DLSw device.

Figure 48 Network diagram

Configuration procedure

# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not

shown.)
# Create a DLSw operation, and configure 10.2.2.2 as the destination IP address.

system-view

[DeviceA] nqa entry admin test1

[DeviceA-nqa-admin-test1] type dlsw

[DeviceA-nqa-admin-test1-dlsw] destination ip 10.2.2.2

# Enable the saving of history records.

[DeviceA-nqa-admin-test1-dlsw] history-record enable

[DeviceA-nqa-admin-test1-dlsw] quit

# Start the DLSw operation.

[DeviceA] nqa schedule admin test1 start-time now lifetime forever

# After the DLSw operation runs for a period of time, stop the operation.

[DeviceA] undo nqa schedule admin test1

# Display the most recent results of the DLSw operation.

[DeviceA] display nqa result admin test1

NQA entry (admin admin, tag test1) test results:

Send operation times: 1 Receive response times: 1

Min/Max/Average round trip time: 19/19/19

Square-Sum of round trip time: 361

Last succeeded probe time: 2011-11-22 10:40:27.7

Extended results: