H3C Technologies H3C S6300 Series Switches - Manual (Page 234)

221
e. Select Service > BIMS > Configuration Management > Software Library from the top
navigation bar.
Figure 14 Configuring software library
f. On the Software Library page, click Import….
g. On the Import CPE Software page, select the software images for the Device_A device class,
add the Device_A class to the Applicable CPEs pane, and then click OK.
h. Repeat the previous two steps to configure a software library entry for equipment room B's
device class.
Figure 15 Importing CPE software
7. Add auto-deployment tasks:
a. Select Service > BIMS > Configuration Management > Deployment Guide from the top
navigation bar.
b. On the Deployment Guide page, click By Device Class in the Auto Deploy Configuration pane.