H3C Technologies H3C S6300 Series Switches - Manual (Page 224)

211
Configuring ACS authentication parameters
To protect the CPE against unauthorized access, configure a CPE username and password for ACS
authentication. When an ACS initiates a connection to the CPE, the ACS must provide the correct
username and password.
NOTE:
The password setting is optional. You may choose to use only a username for authentication.
To configure ACS authentication parameters:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter CWMP view. cwmp N/A
3. Configure the username for
authentication to the CPE.
cwmp cpe username username
By default, no username has been
configured for authentication to the
CPE.
4. (Optional.) Configure the
password for authentication
to the CPE.
cwmp cpe password { cipher |
simple } password
By default, no password has been
configured for authentication to the
CPE.
Configuring the provision code
The ACS uses the provision code to identify services assigned to each CPE. For correct configuration
deployment, make sure the same provision code is configured on the CPE and the ACS.
To configure the provision code:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter CWMP view. cwmp N/A
3. Configure the provision code. cwmp cpe provision-code
provision-code
The default provision code is
PROVISIONINGCODE.
Configuring the CWMP connection interface
The CWMP connection interface is the interface that the CPE uses to communicate with the ACS. To
establish a CWMP connection, the CPE sends the IP address of this interface in the Inform messages,
and the ACS replies to this IP address.
Typically, the CPE selects the CWMP connection interface automatically.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address on
the device, you do not need to specify the CWMP connection interface.
If the CPE has multiple Layer 3 interfaces, specify the interface that connects to the ACS as the CWMP
connection interface. This manual setting avoids the risk of incorrect CWMP connection interface
selection in an automatic selection process.