beautypg.com

Http operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual

Page 158

background image

145

Min/Max/Average round trip time: 173/173/173

Square-Sum of round trip time: 29929

Last succeeded probe time: 2011-11-22 10:07:28.6

Extended results:

Packet loss ratio: 0%

Failures due to timeout: 0

Failures due to disconnect: 0

Failures due to no connection: 0

Failures due to internal error: 0

Failures due to other errors: 0

# Display the history records of the FTP operation.

[DeviceA] display nqa history admin test1

NQA entry (admin admin, tag test1) history records:

Index Response Status Time

1 173 Succeeded 2011-11-22 10:07:28.6

The output shows that Device A uses 173 milliseconds to upload a file to the FTP server.

HTTP operation configuration example

Network requirements

As shown in

Figure 42

, configure an HTTP operation on the NQA client to test the time required to obtain

data from the HTTP server.

Figure 42 Network diagram

Configuration procedure

# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not

shown.)
# Create an HTTP operation.

system-view

[DeviceA] nqa entry admin test1

[DeviceA-nqa-admin-test1] type http

# Specify the URL of the HTTP server.

[DeviceA-nqa-admin-test-http] url http://10.2.2.2/index.htm

# Configure the HTTP operation to get data from the HTTP server. (The default HTTP operation type is get,
and this step can be omitted.)

[DeviceA-nqa-admin-test1-http] operation get

# Configure the operation to use HTTP version 1.0. (Version 1.0 is the default version, and this step can
be omitted.)

[DeviceA-nqa-admin-test1-http] version v1.0