H3C Technologies H3C S12500-X Series Switches - Manual (Page 97)

83
Step Command Remarks
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the router as a
stub router.
stub-router [ external-lsa
[ max-metric-value ] | include-stub |
on-startup { seconds | wait-for-bgp
[ seconds ] } | summary-lsa
[ max-metric-value ] ] *
By default, the router is not
configured as a stub router.
A stub router has no associations
with a stub area.
215B
Configuring OSPF authentication
Perform this task to configure OSPF area and interface authentication.
OSPF adds the configured password into sent packets, and uses the password to authenticate received
packets. Only packets that pass the authentication can be received. If a packet fails the authentication,
the OSPF neighbor relationship cannot be established.
If you configure OSPF authentication for both an area and an interface in that area, the interface uses the
OSPF authentication configured on it.
495B
Configuring OSPF area authentication
You must configure the same authentication mode and password on all the routers in an area.
To configure OSPF area authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enter area view. area area-id N/A
4. Configure area authentication
mode.
• Configure MD5 authentication:
authentication-mode { hmac-md5 |
md5 } key-id { cipher | plain } password
• Configure simple authentication:
authentication-mode simple { cipher |
plain } password
Use either method.
By default, no
authentication is
configured.
496B
Configuring OSPF interface authentication
You must configure the same authentication mode and password on both the local interface and its peer
interface.
To configure OSPF interface authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A