H3C Technologies H3C S12500-X Series Switches - Manual (Page 153)

139
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify the interval for
sending CSNP packets on the
DIS of a broadcast network.
isis timer csnp seconds [ level-1 |
level-2 ]
The default setting is 10 seconds.
272B
Configuring a DIS priority for an interface
On a broadcast network, IS-IS must elect a router as the DIS at a routing level. You can specify a DIS
priority at a level for an interface. The greater the interface's priority, the more likely it becomes the DIS.
If multiple routers in the broadcast network have the same highest DIS priority, the router with the highest
MAC address becomes the DIS.
To configure a DIS priority for an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a DIS priority for
the interface. isis dis-priority value [ level-1 |
level-2 ]
The default setting is 64.
273B
Disabling an interface from sending/receiving IS-IS packets
After being disabled from sending and receiving hello packets, an interface cannot form any neighbor
relationship, but can advertise directly connected networks in LSPs through other interfaces. This can save
bandwidth and CPU resources, and ensures that other routers know networks directly connected to the
interface.
To disable an interface from sending and receiving IS-IS packets:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Disable the interface from
sending and receiving IS-IS
packets.
isis silent
By default, the interface can send
and receive IS-IS packets.
274B
Enabling an interface to send small hello packets
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
Any two IS-IS neighboring routers must negotiate a common MTU. To avoid sending big hellos to save
bandwidth, enable the interface to send small hello packets without CLVs.