H3C Technologies H3C S12500-X Series Switches - Manual (Page 137)

123
5B
Configuring IS-IS
This chapter describes how to configure IS-IS for IPv4 networks.
58B
Overview
Intermediate System-to-Intermediate System (IS-IS) is a dynamic routing protocol designed by the ISO to
operate on the connectionless network protocol (CLNP).
IS-IS was modified and extended in RFC 1195 by the IETF for application in both TCP/IP and OSI
reference models, called "Integrated IS-IS" or "Dual IS-IS."
IS-IS is an IGP used within an AS. It uses the SPF algorithm for route calculation.
248B
Terminology
• Intermediate system—Similar to a router in TCP/IP, IS is the basic unit used in an IS-IS routing
domain to generate and propagate routing information. Throughout this chapter, an IS refers to a
router.
• End system—Similar to a host in TCP/IP, an ES does not run IS-IS. ISO defines the ES-IS protocol for
communication between an ES and an IS.
• Routing domain—An RD comprises a group of ISs that exchange routing information with each
other by using the same routing protocol.
• Area—An IS-IS routing domain can be split into multiple areas.
• Link State Database—All link states in the network form the LSDB. Each IS has at least one LSDB. An
IS uses the SPF algorithm and LSDB to generate IS-IS routes.
• Link State Protocol Data Unit or Link State Packet —An IS advertises link state information in an LSP.
• Network Protocol Data Unit—An NPDU is a network layer protocol packet in OSI, similar to an IP
packet in TCP/IP.
• Designated IS—A DIS is elected on a broadcast network.
• Network service access point—An NSAP is an OSI network layer address. The NSAP identifies an
abstract network service access point and describes the network address format in the OSI
reference model.
249B
IS-IS address format
532B
NSAP
As shown in
1001H
Figure 32 , an NSAP address comprises the Initial Domain Part (IDP) and the Domain
Specific Part (DSP). The IDP is analogous to the network ID of an IP address, and the DSP is analogous
to the subnet and host ID.
The IDP includes the Authority and Format Identifier (AFI) and the Initial Domain Identifier (IDI).
The DSP includes:
• High Order Part of DSP (HO-DSP)—Identifies the area.