H3C Technologies H3C S12500-X Series Switches - Manual (Page 337)

323
To configure a virtual link:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter OSPFv3 area view. area area-id N/A
4. Configure a virtual link.
vlink-peer router-id [ dead seconds |
hello seconds | instance instance-id |
retransmit seconds | trans-delay
seconds ] *
By default, no virtual link is
configured.
107B
Configuring OSPFv3 network types
OSPFv3 classifies networks into the following types by the link layer protocol:
• Broadcast—When the link layer protocol is Ethernet or FDDI, OSPFv3 considers the network type
as broadcast by default.
• NBMA—When the link layer protocol is ATM, Frame Relay, or X.25, OSPFv3 considers the network
type as NBMA by default.
• P2P—When the link layer protocol is PPP, LAPB, HDLC, or POS, OSPFv3 considers the network type
as P2P by default.
Follow these guidelines when you change the network type of an OSPFv3 interface:
• An NBMA network must be fully connected. Any two routers in the network must be directly
reachable to each other through a virtual circuit. If no such direct link is available, you must change
the network type through a command.
• If direct connections are not available between some routers in an NBMA network, the type of
interfaces associated must be configured as P2MP, or as P2P for interfaces with only one neighbor.
390B
Configuration prerequisites
Before you configure OSPFv3 network types, enable OSPFv3.
391B
Configuring the OSPFv3 network type for an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a network type for
the OSPFv3 interface.
ospfv3 network-type { broadcast |
nbma | p2mp [ unicast ] | p2p }
[ instance instance-id ]
By default, the network type of an
interface depends on the media type
of the interface.