H3C Technologies H3C S12500-X Series Switches - Manual (Page 327)

313
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable RIPng and enter RIPng
view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Enable the GR capability for
RIPng.
graceful-restart By default, RIPng GR is disabled.
101B
Displaying and maintaining RIPng
Execute display commands in any view and reset commands in user view.
Task Command
Display configuration information of a RIPng
process.
display ripng [ process-id ]
Display routes in the RIPng database. display ripng process-id database [ ipv6-address prefix-length ]
Display the routing information of a specified
RIPng process. display ripng process-id route [ ipv6-address prefix-length
[ verbose ] | peer ipv6-address | statistics ]
Display RIPng interface information.
display ripng process-id interface [ interface-type
interface-number ]
Reset a RIPng process. reset ripng process-id process
Clear statistics of a RIPng process. reset ripng process-id statistics
102B
RIPng configuration examples
382B
Basic RIPng configuration example
664B
Network requirements
As shown in
1199H
Figure 77 , all switches run RIPng. Configure Switch B to filter the route 2::/64 learned from
Switch A and to forward only the route 4::/64 to Switch A.
Figure 77 Network diagram
665B
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Switch A.
system-view