H3C Technologies H3C S12500-X Series Switches - Manual (Page 269)

255
Figure 62 Network diagram
615B
Configuration considerations
On Switch A, establish EBGP connections with Switch B and Switch C. Configure BGP to advertise
network 8.1.1.0/24 to Switch B and Switch C, so that Switch B and Switch C can access the internal
network connected to Switch A.
On Switch B, establish an EBGP connection with Switch A and an IBGP connection with Switch C.
Configure BGP to advertise network 9.1.1.0/24 to Switch A, so that Switch A can access the intranet
through Switch B. Configure a static route to interface loopback 0 on Switch C (or use a routing protocol
like OSPF) to establish the IBGP connection.
On Switch C, establish an EBGP connection with Switch A and an IBGP connection with Switch B.
Configure BGP to advertise network 9.1.1.0/24 to Switch A, so that Switch A can access the intranet
through Switch C. Configure a static route to interface loopback 0 on Switch B (or use another protocol
like OSPF) to establish the IBGP connection.
Configure load balancing on Switch A.
616B
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure BGP connections:
# Configure Switch A.
system-view
[SwitchA] bgp 65008
[SwitchA-bgp] router-id 1.1.1.1
[SwitchA-bgp] peer 3.1.1.1 as-number 65009
[SwitchA-bgp] peer 3.1.2.1 as-number 65009
[SwitchA-bgp] address-family ipv4 unicast
[SwitchA-bgp-ipv4] peer 3.1.1.1 enable
[SwitchA-bgp-ipv4] peer 3.1.2.1 enable
[SwitchA-bgp-ipv4] network 8.1.1.1 24
[SwitchA-bgp-ipv4] quit
[SwitchA-bgp] quit
# Configure Switch B.
system-view