H3C Technologies H3C S12500-X Series Switches - Manual (Page 311)

297
Step Command Remarks
3. Configure BFD echo
mode for an IPv6
static route.
• Method 1:
ipv6 route-static ipv6-address prefix-length
interface-type interface-number
next-hop-address bfd echo-packet
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
• Method 2:
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address
prefix-length interface-type
interface-number next-hop-address bfd
echo-packet [ preference preference-value ]
[ tag tag-value ] [ description
description-text ]
Use either method.
By default, BFD echo mode for
an IPv6 static route is not
configured.
The next hop IPv6 address must
be a global unicast address.
93B
Displaying and maintaining IPv6 static routes
Execute display commands in any view.
Task Command
Display IPv6 static route information. display ipv6 routing-table protocol static [ inactive | verbose ]
Display IPv6 static route next hop information. display ipv6 route-static nib [ nib-id ] [ verbose ]
Display IPv6 static routing table information.
display ipv6 route-static routing-table [ vpn-instance
vpn-instance-name ] [ ipv6-address prefix-length ]
94B
IPv6 static routing configuration examples
366B
Basic IPv6 static route configuration example
653B
Network requirements
As shown in
1180H
Figure 74 , configure IPv6 static routes so that hosts can reach one another.