H3C Technologies H3C S12500-X Series Switches - Manual (Page 144)

130
• RFC 2966, Domain-wide Prefix Distribution with Two-Level IS-IS
• RFC 2973, IS-IS Mesh Groups
• RFC 3277, IS-IS Transient Blackhole Avoidance
• RFC 3358, Optional Checksums in ISIS
• RFC 3373, Three-Way Handshake for IS-IS Point-to-Point Adjacencies
• RFC 3567, Intermediate System to Intermediate System (IS-IS) Cryptographic Authentication
• RFC 3719, Recommendations for Interoperable Networks using IS-IS
• RFC 3786, Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit
• RFC 3787, Recommendations for Interoperable IP Networks using IS-IS
• RFC 3847, Restart Signaling for IS-IS
• RFC 4444, Management Information Base for Intermediate System to Intermediate System (IS-IS)
59B
IS-IS configuration task list
Tasks at a glance
1006H
Configuring basic IS-IS :
• (Required.)
1007H
Enabling IS-IS
• (Optional.)
1008H
Configuring the IS level and circuit level
• (Optional.)
1009H
Configuring P2P network type for an interface
(Optional.)
1010H
Configuring IS-IS route control :
•
1011H
Configuring IS-IS link cost
•
1012H
Specifying a preference for IS-IS
•
1013H
Configuring the maximum number of ECMP routes
•
1014H
Configuring IS-IS route summarization
•
1015H
Advertising a default route
•
1016H
Configuring IS-IS route redistribution
•
1017H
Configuring IS-IS route filtering
•
1018H
Configuring IS-IS route leaking
(Optional.)
1019H
Tuning and optimizing IS-IS networks :
•
1020H
Specifying the interval for sending IS-IS hello packets
•
1021H
Specifying the IS-IS hello multiplier
•
1022H
Specifying the interval for sending IS-IS CSNP packets
•
1023H
Configuring a DIS priority for an interface
•
1024H
Disabling an interface from sending/receiving IS-IS packets
•
1025H
Enabling an interface to send small hello packets
•
1026H
Configuring LSP parameters
•
1027H
Controlling SPF calculation interval
•
1028H
Configuring convergence priorities for specific routes
•
1029H
Setting the LSDB overload bit
•
1030H
Configuring system ID to host name mappings
•
1031H
Enabling the logging of neighbor state changes
•
1032H
Enabling IS-IS ISPF
•
1033H
Configuring IS-IS network management