Configuring match criteria for a node, Configuring actions for a node – H3C Technologies H3C S12500-X Series Switches User Manual
Page 392
378
[SwitchB-route-policy-isis2ospf-30] quit
6.
Apply the routing policy to route redistribution:
# On Switch B, enable route redistribution from IS-IS and apply the routing policy.
[SwitchB] ospf
[SwitchB-ospf-1] import-route isis 1 route-policy isis2ospf
[SwitchB-ospf-1] quit
# Display the OSPF routing table on Switch A.
[SwitchA] display ospf routing
OSPF Process 1 with Router ID 192.168.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
192.168.1.0/24 1 Transit 192.168.1.1 192.168.1.1 0.0.0.0
Routing for ASEs
Destination Cost Type Tag NextHop AdvRouter
172.17.1.0/24 100 Type2 1 192.168.1.2 192.168.2.2
172.17.2.0/24 1 Type2 20 192.168.1.2 192.168.2.2
172.17.3.0/24 1 Type2 1 192.168.1.2 192.168.2.2
Total Nets: 4
Intra Area: 1 Inter Area: 0 ASE: 3 NSSA: 0
The output shows that the cost of route 172.17.1.0/24 is 100 and the tag of route
172.17.2.0/24 is 20.
444B
Applying a routing policy to IPv6 route redistribution
704B
Network requirements
•
As shown in
1253H
Figure 89
, run RIPng on Switch A and Switch B.
•
On Switch A, configure three static routes, and apply a routing policy to static route redistribution
to permit routes 20::0/32 and 40::0/32 and deny route 30::0/32.
Figure 89 Network diagram
705B
Configuration procedure
1.
Configure Switch A:
# Configure IPv6 addresses for VLAN-interface 100 and VLAN-interface 200.