Specifying a rip neighbor – H3C Technologies H3C S12500-X Series Switches User Manual

Page 62

Figure 11 Network diagram

475B

Configuration procedure

Configure IP addresses for interfaces. (Details not shown.)

Configure basic RIP:
# Configure Switch A.

system-view

[SwitchA] rip 1

[SwitchA-rip-1] version 2

[SwitchA-rip-1] undo summary

[SwitchA-rip-1] network 192.168.1.0

[SwitchA-rip-1] quit

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] rip bfd enable

[SwitchA-Vlan-interface100] quit

[SwitchA] rip 2

[SwitchA-rip-2] version 2

[SwitchA-rip-2] undo summary

[SwitchA-rip-2] network 192.168.2.0

[SwitchA-rip-2] quit

# Configure Switch B.

system-view

[SwitchB] rip 1

[SwitchB-rip-1] version 2

[SwitchB-rip-1] undo summary

[SwitchB-rip-1] network 192.168.2.0

[SwitchB-rip-1] network 192.168.3.0

[SwitchB-rip-1] quit

# Configure Switch C.

system-view

[SwitchC] rip 1

[SwitchC-rip-1] version 2

[SwitchC-rip-1] undo summary

[SwitchC-rip-1] network 192.168.1.0

This manual is related to the following products: