Displaying and maintaining static routes, Static route configuration examples, Basic static route configuration example – H3C Technologies H3C S12500-X Series Switches User Manual
Page 26
12
Step Command
Remarks
3.
Configure static route
FRR.
•
Method 1:
ip route-static dest-address { mask-length |
mask } interface-type interface-number
[ next-hop-address [ backup-interface
interface-type interface-number
[ backup-nexthop
backup-nexthop-address ] ] ] [ permanent ]
•
Method 2:
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } interface-type
interface-number [ next-hop-address
[ backup-interface interface-type
interface-number [ backup-nexthop
backup-nexthop-address ] ] ] [ permanent ]
Use either method.
By default, static route FRR is
not configured.
30B
Displaying and maintaining static routes
Execute display commands in any view.
Task Command
Display static route information.
display ip routing-table protocol static [ inactive | verbose ]
Display static route next hop
information.
display route-static nib [ nib-id ] [ verbose ]
Display static routing table
information.
display route-static routing-table [ vpn-instance vpn-instance-name ]
[ ip-address { mask-length | mask } ]
31B
Static route configuration examples
136B
Basic static route configuration example
445B
Network requirements
Configure static routes on the switches in
895H
Figure 2
for interconnections between any two hosts.