H3C Technologies H3C S12500-X Series Switches - Manual (Page 30)

16
450B
Verifying the configuration
# Display BFD sessions on Switch A.
display bfd session
Total Session Num: 1 Up Session Num: 1 Init Mode: Active
IPv4 Session Working Under Ctrl Mode:
LD/RD SourceAddr DestAddr State Holdtime Interface
4/7 12.1.1.1 12.1.1.2 Up 2000ms Vlan10
The output shows that the BFD session has been created.
# Display the static routes on Switch A.
display ip routing-table protocol static
Summary Count : 1
Static Routing table Status :
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 12.1.1.2 Vlan10
Static Routing table Status :
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 10. Then the link
over VLAN-interface 10 fails.
# Display static routes on Switch A.
display ip routing-table protocol static
Summary Count : 1
Static Routing table Status :
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 Vlan11
Static Routing table Status :
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11.