H3C Technologies H3C S12500-X Series Switches - Manual (Page 303)

289
88B
Configuring PBR
360B
Configuring local PBR
Configure PBR by applying a policy locally. PBR uses the policy to guide the forwarding of locally
generated packets. The specified policy must already exist. Otherwise, the local PBR configuration fails.
You can apply only one policy locally. Before you apply a new policy, you must first remove the current
policy.
Do not configure local PBR unless required.
To configure local PBR:
Step Command Remarks
1. Enter system view. system-view N/A
2. Apply a policy locally.
ip local policy-based-route
policy-name By default, no policy is locally
applied.
361B
Configuring interface PBR
Configure PBR by applying a policy to an interface. PBR uses the policy to guide the forwarding of
packets received on the interface. The specified policy must already exist. Otherwise, the interface PBR
configuration fails.
You can apply only one policy to an interface. Before you apply a new policy, you must first remove the
current policy from the interface.
You can apply a policy to multiple interfaces.
To configure interface PBR:
Step Command Remarks
1. Enter system
view.
system-view N/A
2. Enter interface
view.
interface interface-type interface-number N/A
3. Apply a policy
to the interface. ip policy-based-route policy-name By default, no policy is applied to the
interface.
89B
Displaying and maintaining PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display PBR policy information. display ip policy-based-route [ policy policy-name ]
Display PBR configuration. display ip policy-based-route setup