H3C Technologies H3C S12500-X Series Switches - Manual (Page 243)

229
Step Command Remarks
4. Specify the maximum number
of BGP ECMP routes for load
balancing.
balance number
By default, load balancing is
disabled.
To specify the maximum number of BGP ECMP routes for load balancing (IPv6):
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
address family view or
BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Specify the maximum number
of BGP ECMP routes for load
balancing. balance number
By default, load balancing is
disabled.
333B
Disabling BGP to establish a session to a peer or peer group
This task enables you to temporarily tear down the BGP session to a specific peer or peer group so that
you can perform network upgrade and maintenance without needing to delete and reconfigure the peer
or peer group. To recover the session, execute the undo peer ignore command.
To disable BGP to establish a session to a peer or peer group (IPv4):
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer { group-name | ip-address }
ignore By default, BGP can establish a
session to a peer or peer group.
To disable BGP to establish a session to a peer or peer group (IPv6):
Step Command Remarks
1. Enter system view. system-view N/A