H3C Technologies H3C S12500-X Series Switches - Manual (Page 315)

301
658B
Verifying the configuration
# Display the BFD sessions on Switch A.
display bfd session
Total Session Num: 1 Up Session Num: 1 Init Mode: Active
IPv6 Session Working Under Ctrl Mode:
Local Discr: 513 Remote Discr: 33
Source IP: FE80::2A0:FCFF:FE00:580A (link-local address of VLAN-interface 10 on
Switch A)
Destination IP: FE80::2E0:FCFF:FE58:123E (link-local address of VLAN-interface 10 on
Switch B)
Session State: Up Interface: Vlan10
Hold Time: 2012ms
The output shows that the BFD session has been created.
# Display IPv6 static routes on Switch A.
display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status :
Summary Count : 1
Destination: 12::/64 Protocol : Static
NextHop : 12::2 Preference: 60
Interface : Vlan10 Cost : 0
Direct Routing table Status :
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 10. The link over
VLAN-interface 10 fails.
# Display IPv6 static routes on Switch A again.
display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status :
Summary Count : 1
Destination: 120::/64 Protocol : Static
NextHop : 10::100 Preference: 65
Interface : Vlan11 Cost : 0
Static Routing table Status : < Inactive>
Summary Count : 0