H3C Technologies H3C S12500-X Series Switches - Manual (Page 323)

309
To configure RIPng route summarization:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Advertise a summary IPv6
prefix. ripng summary-address ipv6-address
prefix-length
By default, the
summary IPv6 prefix
is not configured.
374B
Advertising a default route
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure RIPng to advertise a
default route. ripng default-route { only |
originate } [ cost cost ]
By default, RIPng does not advertise a
default route.
This command advertises a default
route on the current interface
regardless of whether the default route
is available in the local IPv6 routing
table.
375B
Configuring received/redistributed route filtering
Perform this task to filter received or redistributed routes by using an IPv6 ACL or IPv6 prefix list. You can
also configure RIPng to filter routes redistributed from other routing protocols and routes from a specified
neighbor.
To configure a RIPng route filtering policy:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a filter policy
to filter received routes. filter-policy { acl6-number | prefix-list
prefix-list-name } import By default, RIPng does not filter
received routes.
4. Configure a filter policy
to filter redistributed
routes.
filter-policy { acl6-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] ]
By default, RIPng does not filter
redistributed routes.