Configuring an ipv6 policy, Creating an ipv6 node, Configuring match criteria for an ipv6 node – H3C Technologies H3C S12500-X Series Switches User Manual
Page 375: Configuring actions for an ipv6 node
361
Tasks at a glance
(Required.)
1243H
Configuring IPv6 PBR
:
•
1244H
Configuring IPv6 local PBR
•
1245H
Configuring IPv6 interface PBR
123B
Configuring an IPv6 policy
424B
Creating an IPv6 node
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
By default, no IPv6 policy
node is created.
425B
Configuring match criteria for an IPv6 node
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
N/A
3.
Configure an ACL
match criterion.
if-match acl { acl6-number | name acl6-name }
By default, no ACL
match criterion is
configured.
NOTE:
If an ACL match criterion is defined, packets are matched against the ACL rules, and the permit or deny
action and the time range of the specified ACL are ignored. If the specified ACL does not exist, no packet
is matched.
426B
Configuring actions for an IPv6 node
Step Command
Remarks
1.
Enter system view. system-view
N/A
2.
Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
N/A