Displaying and maintaining rip, Configuring rip frr – H3C Technologies H3C S12500-X Series Switches User Manual
Page 70
56
Summary Count : 1
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
SubProtID: 0x1 Age: 00h18m40s
Cost: 2 Preference: 100
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0x2 OrigAs: 0
NBRID: 0x12000003 LastAs: 0
AttrID: 0xffffffff Neighbor: 192.168.3.2
Flags: 0x1008c OrigNextHop: 192.168.3.2
Label: NULL RealNextHop: 192.168.3.2
BkLabel: NULL BkNextHop: N/A
Tunnel ID: Invalid Interface: vlan-interface 300
BkTunnel ID: Invalid BkInterface: N/A
176B
Configuring RIP FRR
483B
Network requirements
As shown in
936H
Figure 14
, Switch S, Switch A, and Switch D run RIPv2. Configure RIP FRR so that when Link
A becomes unidirectional, services can be switched to Link B immediately.
Figure 14 Network diagram
484B
Configuration procedure
1.
Configure IP addresses and subnet masks for interfaces on the switches. (Details not shown.)
2.
Configure RIPv2 on the switches to make sure Switch A, Switch D, and Switch S can communicate
with each other at Layer 3. (Details not shown.)
3.
Configure RIP FRR:
# Configure Switch S.
[SwitchS] bfd echo-source-ip 1.1.1.1
[SwitchS] ip prefix-list abc index 10 permit 4.4.4.4 32
[SwitchS] route-policy frr permit node 10
[SwitchS-route-policy-frr-10] if-match ip address prefix-list abc