Teac SX-1 Reference Manual - Manual (Page 61)

Part IV–Mixer Controls
TASCAM SX-1 Reference Manual
61
Actually routing the insert to a mixer channel
Once you have created an insert on the insert routing
page, you’ll want to actually insert it on a mixer
channel to hear it. While you can do this in a few dif-
ferent places on the VGA, the manner of selection is
the same for all of them. Go back to the Mixer page (
MIXER
key in the
MAIN
DISPLAY MODES
section of the surface, or press
Alt+2 on the PS/2 keyboard), and look at the top of a
channel strip for the
Insert
button:
Right-clicking on the
Insert
button will bring up this
dialog:
Here, you can select which insert the channel in
question actually uses – as well as determining
whether the insert is pre- or post-EQ. Each channel
can access one insert at a time, and the last selection
will send the view back to the
Routing
screen’s
Insert
Presets
tab.
To use the insert, click the insert button normally
(with the left mouse button). The button will light red
to indicate that the insert is active.
The same button can be
viewed on the VGA
Channel
screen, as seen to the right.