Teac SX-1 Reference Manual - Manual (Page 26)

Part II–Monitoring Signals and Selecting Screens
26
TASCAM SX-1 Reference Manual
Indicates that the digital input con-
nected to one of the rear digital input ports is the
master clock source.
Indicates that a device connected
to an optional card installed in one of the Option
Slots is the master clock source.
Shows that incoming ADAT
Optical (on the rear panel) is the master clock source.
SAMPLE RATE These LED indicators reflect the
SX-1’s current sample rate.
<44.1KHZ>
Indicates that the current sample rate is
44.1 kHz.
<48KHZ>
Indicates that the current sample rate is
48 kHz.
<2X>
Shows that the current sample rate is one of the
two high sample rate settings (88.1 kHz or 96 kHz).
For example, at 88.2 kHz, both the 44.1kHz and 2X
indicators will light. High sampling rates will be
available in Version 2.
HDR RECORD These LED indicators reflect the
Hard Disk Recorder’s resolution, input and record
monitoring states.
<24 -BIT>
Indicates that the SX-1 is set to record at
24-bit resolution.
Shows that the All Input monitor
mode is selected.
Shows that the Auto Monitor
mode is selected.
ACTIVITY These LED indicators display hard disk
and MIDI activity.
Indicates that the hard drive is accessing.
Indicates the existence of incoming or outgo-
ing MIDI data. The actual operation depends on the
MIDI LED setting on the LCD
Preferences
page.
Master Stereo Meter The Master Stereo Meter
provides a visual cue of your master output buss. It is
a 30-segment LED that goes from –60 to 0 dB and
features peak LED indicators to show digital “overs.”
TIP
To see discrete meters for each mixer channel, go to the
Overview screen by pressing OVERVIEW in the MAIN
DISPLAY MODES section.