Teac SX-1 Reference Manual - Manual (Page 52)

Part IV–Mixer Controls
52
TASCAM SX-1 Reference Manual
Buss Routing This button opens the
selected channel’s Buss Routing dialog:
1-2 to 7-8 Use these buttons to send sig-
nals from the selected channel to busses
1-8.
CUE Use this button to send signal from
the selected channel to the Cue buss.
ST
Use this button to send signal from
the selected channel to the Master stereo
buss.
INPUT button This menu houses the controls for
phase polarity and EQ/dynamics order.
INSERT button This menu houses the controls for
switching the insert on and off, insert number and
point selection.
TRIM/CH DELAY Screen Trim and channel
delay controls are available from the LCD. The trim
controls are different from the pre-mixer channel
input trim controls found on the top of the SX-1.
These trim controls allow you to adjust the level of
mixer channels from –20 to +20 dB before it reaches
the fader. The delay function lets you delay individ-
ual channels from 0 to 8191 samples. On the VGA,
the trim and delay controls are found on the
POSITION
module of the
Channel
screen.
To reach this screen, press the
DELAY/ TRIM
key in
the
LCD ACCESS
section. To reach a channel, press
the soft key next to the Trim or Delay group that the
channel belongs to. To select a channel for editing,
use the keypad’s up/down arrow keys.
COPY TO ALL Use this key to copy the delay and
trim settings of the currently selected channel to all
of the mixer’s channels.