Teac SX-1 Reference Manual - Manual (Page 184)

Part VIII–Data Entry, System & File Management
184
TASCAM SX-1 Reference Manual
Press
SHIFT
on the Keypad. Then, from the
MAIN
DISPLAY MODE
section, press
SETTINGS/ PREFS
,
and use the
NEXT PAGE
(or
PREV PAGE
) soft key to scroll
to the
MISC
screen.
FOOT PEDAL Allows you to set the foot pedal
jack’s operation to
Normally Open
or
Normally Closed
.
FOOT PEDAL ASSIGN Allows the assignment of
the footswitch function.
NOTE
The foot pedal's default operation is as a punch-in
pedal for recording. In future versions it will have
expanded capabilities
REG DIM LEVEL Here, you can set the amount of
level attenuation (–50 to –3dB) for the
DIM
key of
the
CONTROL ROOM
section.
TB DIM LEVEL Use this control to set the amount
of Main Output level attenuation (–50 to –3dB) asso-
ciated with the
TALKBACK
key of the
STUDIO
section.
CTL ATT LEVEL Use this parameter to adjust the
starting level for the Control Room outs. The default
of
0
is equivalent to +4 dBu.
ST ATT LEVEL Use this parameter to adjust the
starting level for the Studio outs. Again, the default
value of
0
is equivalent to +4dBu.
FADER SENSITIVITY Adjusts the touch-sensitiv-
ity of the faders. The values are expressed in scan
cycles, with higher values denoting faster (and there-
fore more accurate) scanning of the faders.
Note that the SX-1 faders’ touch-sensitivity depends
somewhat on the environment; chiefly temperature
and humidity, and body pH—as these all affect con-
ductivity.
VGA REFRESH RATE Use this dial to select your
VGA screen’s sync rate (60 to 87 Hz).
LCD Time Screen
Everything you do on the SX-1 is time and date
stamped. This is essential for event history and undo/
redo operations. Use this screen to set the SX-1’s
internal time. Press
SHIFT
on the Keypad. Then, from the
MAIN
DISPLAY MODE
section, press
SETTINGS/ PREFS
,
and use the
NEXT PAGE
(or
PREV PAGE
) soft key to scroll
to the
TIME
screen.
SET TIME Once you have adjusted the time and
date, press this soft key to set the SX-1’s internal
clock.
SELECT MONTH and SELECT HOUR Turn
this soft knob to adjust the month or hour, depending
on the field that is selected.
SELECT DAY and SELECT MINUTE Turn this
soft knob to adjust the day or minute, depending on
the field that is selected.
SELECT YEAR and SELECT SECOND Turn
this soft knob to adjust the year or second, depending
on the field that is selected.
About your SX-1
There are no editable parameters on this screen—it
simply provides information about some of the SX-1
hardware components.