Teac SX-1 Reference Manual - Manual (Page 190)

Part VIII–Data Entry, System & File Management
190
TASCAM SX-1 Reference Manual
Digital I/O Settings
When you have another digital audio device hooked
up to the SX-1 via its
DIGITAL I/O
jacks, you want to
make sure that the SX-1’s I/O matches the other
device’s I/O settings. These parameters can be
adjusted from the LCD screen.
TIP
The SX-1 can perform sample rate conversion (SRC) in
real time via the SDPIF inputs. For example, if your
project is at 48kHz but you want to input something
that was recorded at 44.1 kHz, set the SX-1’s digital
input to 48 kHz.
LCD Digital I/O Screens
From the
MAIN DISPLAY MODE
section, press
SETTINGS/ PREFS
, and use the
NEXT PAGE
(or
PREV
PAGE
) soft key to scroll to the
DI /O
screen. Then, use
the appropriate soft keys to jump to the Digital I/O
you want to set. The default screens for the onboard
S/PDIF jacks are shown below.
FS CONVERT Turns the input sampling frequency
conversion on or off. When on, sampling frequencies
from 32kHz to 48kHz are automatically converted to
the current mixer sample rate.
FS OVERRIDE Overrides the current mixer sample
rate, if sample rate of the source at this jack is
different.
MUTE DEFEAT Normally, when the SX-1 detects
a clock outside its limits of tolerance (±6%) from the
nominal sample rate of that source (e.g. a varispeed
source), the console mutes. This setting allows you to
defeat this operation.