Comtech EF Data SNM-1001L - Manual (Page 88)

SNM-1001L Satellite Modem Revision 1
Front Panel Operation MN/SNM1001L.IOM
4–24
FUNCTION SELECT: CONFIGURATION: DEMODULATOR:
REACQUISITION
REACQUISITION
0 SECONDS
Programs the sweep reacquisition mode time duration. This is the time that the modem will
remain in a narrow sweep after loss of acquisition. After this timer runs out, the modem will
return to the normal acquisition sweep. The reacquisition time is 0 to 999 seconds.
Upon entry, the current programmed setting is displayed with a flashing cursor on the first
character. Press [
←] or [→] to move the flashing cursor. Press [↑] or [↓] to increment or
decrement the digit at the flashing cursor. Select the number of seconds desired for the
reacquisition mode. Press to execute the change.
FUNCTION SELECT: CONFIGURATION: DEMODULATOR:
LNB POWER
LNB POWER
OFF
Programs the LNB Power On or Off. The LNB voltage is transmitted up the center conductor of
the RF-IF connector.
Upon entry, the current status of the descrambler is displayed. Press [
↑] or [↓] to make the
selection. Press to execute the change.
FUNCTION SELECT: CONFIGURATION: DEMODULATOR:
LNB VOLTAGE
LNB VOLTAGE
13 VDC
Programs the LNB Power at 13, 18, or 24 VDC.
Upon entry, the current status of the descrambler is displayed. Press [
↑] or [↓] to make the
selection. Press to execute the change.