Comtech EF Data SNM-1001L - Manual (Page 275)

B–1
Appendix B. REMOTE CONTROL
OPERATION
This appendix describes the remote control operation of the SNM-1001L.
Firmware number: FW/8460-1M
Software version: 2.1.12
Note: The firmware referenced in this manual may be an earlier version of the actual firmware
supplied with the unit.
B.1 General
Remote controls and status information are transferred via an EIA-485 or EIA-232 serial
communications link menu selection.
Commands and data are transferred on the remote control communications link as US ASCII-
encoded character strings.
The remote control port baud rates can be selected from 110 to 38400 kbps.
The remote communications link is operated in a half-duplex mode.
Communications on the remote link are initiated by a remote controller or terminal. The modem
never transmits data on the link unless it is commanded to do so.
The modem must be placed in Remote Mode by entering the REM command prior to performing
a configuration change.