Comtech EF Data SNM-1001L - Manual (Page 311)

SNM-1001L Satellite Modem Revision 1
Remote Control Operation MN/SNM1001L.IOM
B–37
Character 'r': Interface Reed-Solomon Unavailable
Seconds
Bit 6 = 1 always.
Bit 5 = not used.
Bit 4 = not used.
Bit 3 through Bit 0 = Binary representation (0 to 10) of
the number of Reed-Solomon Unavailable Seconds
stored faults.
Character 's': Outdoor Unit Status Character 1.
Bit 6 = 1 always.
Bit 5 = Current.
Bit 4 = Voltage.
Bit 3 through Bit 0 = Binary representation (0 to 10) of
the number of Outdoor Unit stored faults.
Character 't': Outdoor Unit Status Character 2.
Bit 6 = 1 always.
Bit 5 = reserved.
Bit 4 = reserved.
Bit 3 = reserved.
Bit 2 = reserved.
Bit 1 = reserved.
Bit 0 = reserved.
Change
Status Command:
Response:
>add/CS_x'cr''lf']
Where:
The 'x' character is defined as follows:
'@' = no change since last BCS_ and BCSF_ polls.
'A' = BCS_ response has changed since last BCS_ poll.
'B' = BCSF_ response has changed since last BCSF_
poll.
'C' = Both responses have changed since last BCS_
and BCSF_ polls.
This command indicates that a change has or has not
occurred on either the BCS_ or the BCSF_ response since
the last BCS_ or BCSF_ poll.
Equipment
Type Command:
Response:
>add/ET_tttttttt_xxx.yyy.zzz'cr''lf']
Where:
tttttttt = Equipment type.
xxx.yyy.zzz = Software version.
Monitor &
Control
Firmware
Information Command:
Response:
>add/MCFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']
Where:
xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
DATA ROM
Firmware
Information Command:
Response:
>add/DFI_'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy’cr’
Turbo: FW/nnnnnn-r'cr''lf']
Where:
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
Note: If Dash number is not used, '-dd' will be reported.
Turbo FW number only reports if Turbo Codec is
installed.