Comtech EF Data SNM-1001L User Manual
Page 291
SNM-1001L Satellite Modem
Revision 1
Remote Control Operation MN/SNM1001L.IOM
B–17
Demod/
Decoder
Config.
Program
Status
Command:
Response:
SMT_xxxxxxx'cr'
IROT_xxxxx'cr'
MOM_xxxxxxx'cr'
BERT_xxxx'cr'
DT_xxxx'cr'
DDT_xxx'cr'
DF_nnnnn.nnnn'cr'
DR_nnnn_mmmm.mmm'cr'
DE_xxx'cr'
DEC_xxx'cr'IFL_xxx’cr’ (Note 9)
SCF_snnnnn'cr'
SWR_nnnnnn'cr'
SR_xxx'cr'
ILT_xxx'cr'
ERF_nnnnn.n'cr'
BC_xxx'cr'
RCP_xxxx'cr'
BBL_xxx'cr'
ILB_xxx'cr'
ICFR_xxxx'cr'
IBP_xxx'cr'
IRE_xxxxxx'cr'
RDF_xxxx'cr'
ISCL_RX1_nnn'cr'
ISCL_RX2_nnn'cr'
RDP_xxxx'cr'
IBS _nnnnnn'cr'
DSR_xxx'cr'
RSDE_xxx'cr'
RXDR_xxxxxx'cr'
ENSP_nn.n'cr' (Note
8)
MAXT_n.n'cr' (Note
8)
RDA_xxx'cr'
RRSI_xx'cr'
R310_xxx'cr'
LNB_xxx’cr’
LNBV_xxx’cr’
LNBR_xxx’cr’
LNBL_xxx’cr’
LNBH_xxx’cr’’lf’]
System Modem Type
Interface Receive Overhead Type
Modem Operation Mode
BER Threshold
Demodulator Type
Demodulator Decoder Type
Demodulator Frequency
Demodulator Rate
Descrambler Enable
Differential Decoder
Sweep Center Frequency
Sweep Width Range
Sweep Reacquisition
Interface Loop Timing
External Reference Frequency
Buffer Clock
Receive Clock Phase
Baseband Loopback
Interface Loopback
Interface Coding Format Receive
Interface Buffer Programming
Interface Read Error (RX 2047)
Receive Data Fault
Service Channel Level RX1
Service Channel Level RX2
Receive Data Phase
Interface Buffer Size
Demodulator Spectrum Rotation
Reed-Solomon Decoder
RX Driver Type
AUPC EBN0 Target Set Point
AUPC Max. Tracking Rate
Receive BPSK Data Ordering
RX Reed-Solomon Interleave Value
RX 8-PSK 2/3 IESS-310 Operation
LNB Power
LNB Voltage
LNB Reference
LNB Current Monitor Low Current Threshold
LNB Current Monitor High Current Threshold
This command is used by the EF Data M:N protection switch to
collect information that is necessary to configure back-up
modems. Because this command (content and/or order) can
be changed at any time by EF Data, it is advisable that other
commands ('DCS_' and 'ICS_', or 'BCS_') be used for M&C
systems.
Notes:
1. Not
Used.
2. Not
Used.
3. Not
Used.
4. Not
Used.
5. Not
Used.
6. Not
Used.
7. Not
Used.
8.
Data is only returned for RX AUPC Overhead.
9.
Data is only returned for the TX/RF L-Band modem