Comtech EF Data SNM-1001L - Manual (Page 158)

SNM-1001L Satellite Modem Revision 1
Front Panel Operation MN/SNM1001L.IOM
4–94
FUNCTION SELECT: MODEM TYPE:
CONFIGURATION CODE – CARD #3 (CONDITIONAL)
CONFIGURATION
CODE – CARD #3
Comtech EF Data-supplied code. Press
IMPORTANT
This menu appears only if the Overhead card is installed.
1)AAAAAAAAAA
2)AAAAAAAAAA
On entry, the current configuration code is displayed with the flashing cursor on the first
character. Press [
← ] or [ → ] to move the flashing cursor. Press [ ↑ ] or [ ↓ ] to increment or decrement
the digit at the flashing cursor. Press to execute the change.
Entering this code enables the corresponding modem option. To purchase an option, contact an
Comtech EF Data marketing representative for more information.
4.3.6.8 FUNCTION SELECT: UTILITY: FACTORY SET-UP
UTILITY
FACTORY SET-UP
CAUTION
This configuration is used for factory alignment. Unauthorized persons
should not change factory setup. Doing so can cause modem failure.