Comtech EF Data SNM-1001L User Manual
Page 314
SNM-1001L Satellite Modem
Revision 1
Remote Control Operation MN/SNM1001L.IOM
B–40
Serial
Number
Command:
Response:
MODEM_xxxxxxxxx'cr'
CARD_1_xxxxxxxxx'cr' (Note
1)
CARD_2_xxxxxxxxx'cr' (Note
2)
CARD_3_xxxxxxxxx'cr''lf'] (Note 3)
Where: xxxxxxxxx = Serial number 000000000 to 999999999.
Notes:
1. Data is only returned if Card #1 is installed.
2. Data is only returned if Card #2 is installed.
3. Data is only returned if Card #3 is installed.
State Of
Product
Command:
Response:
add'cr'
abc'cr'
rrrrr bps'cr'
Product Address
Data Format
Baud Rate
Comm Type
Where: abc = Explained below.
a = Number of data bits (7).
b = Parity type (O, E, N).
c = Number of stop bits (2).
rrrrr = baud rate ("150", "300", "600", "1200", "2400",
"4800", "9600", "14.4K", "19.2K").
communication hardware type "RS-485, 2 wire", "RS-485,
4 wire", "RS-232".
intention of the product. "Under normal system operation",
"REFLASH of BULK firmware required", "REFLASH of
M&C firmware required".