Comtech EF Data HPCST-5000 - Manual (Page 85)

High-Power C-Band Satellite Terminal Redundant System Installation
Rev. 0 4–3
4.1 Unpacking
Note: The HPCST-5000 terminal system is shipped in multiple cartons.
Remove the parts as follows:
1. Cut the tape at the top of each carton where it is indicated OPEN THIS END.
2. Lift out the cardboard/foam spacer covering the units.
CAUTION
1. The redundant assembly may be too heavy to be removed by one
individual, assistance may be required.
2. Do not lift the redundant SSPA assembly by the waveguide. Lift
assembly by the mounting frame only. Extreme care shall be given
to the waveguide assembly during removal. Damage to the
redundant assembly may be the result.
3. Remove the parts from the cartons. Refer to Section 4.2.1 for a parts breakdown.
4. If required, remove the screws from the lid of the wooden crate, and remove the
lid.
5. Unbolt and remove the redundant LNA plate from the crate.
6. Remove the remainder of the parts from the crate. Refer to Section 4.2.1 for a
parts breakdown.
Note: Save the packing material for reshipment, if required.