Comtech EF Data HPCST-5000 - Manual (Page 110)

Redundant System Installation High-Power C-Band Satellite Terminal
4–28 Rev. 0
4. Release pressure on the spring nut. Mount the configuration as follows:
a. Lift the C-Band SSPA into position.
b. Using four 5/16-18 bolts, 5/16”
split lockwashers, and 5/16” flat
washers, bolt the two spar support
brackets in place.
c. Tighten the bolts firmly.
4.4 Redundancy Configuration Cabling Matrix
Refer to Figure 4-5 to determine the proper length of cable assemblies needed to connect
the redundant configuration.
Note: Refer to Chapter 8 for the part number corresponding to the length of cable
required for the redundant configuration. Contact EFData Customer Support for
obtaining the required cable assemblies.