Comtech EF Data HPCST-5000 - Manual (Page 117)

High-Power C-Band Satellite Terminal Operation
Rev. 0 5–5
5.4.1 Configuration
Refer to Figure 5-3.
Terminal configuration may be viewed or changed by entering the CONFIG menu from
the SELECT menu on the front panel.
Enter the selected configuration menu by pressing [ENTER]. Press [ " ] or [ # ] to view
the selected configuration parameters. To change a configuration parameter, press
[ENTER] to begin the change process, at which point the arrow keys can be used to
make the changes.
After the changes are made and the display represents the correct parameters, execute the
change by pressing [ENTER]. When [ENTER] is pressed, the necessary programming is
initiated by the RFT-500.
To undo a parameter change prior to executing it, simply press [CLEAR].
The following table describes each configuration function in detail.